1 / 4
TwoTrees Blu-5/Bluer Plus Wire Harness
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
You'll need: 4 m3x15mm screws for the top piece 4 m3x6mm for the wire harness adapter (4 Threaded brass 5mm inserts if…
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 13
- Makes
- 0
- Views
- 179
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution
You'll need:
4 m3x15mm screws for the top piece
4 m3x6mm for the wire harness adapter
(4 Threaded brass 5mm inserts if you want to use the mount made for that)
Assembly:
You can leave the Hot end attached to the printer.
- Remove electronics housing cover under the extruder
- Unplug all harness wires (Pay attention to were each one goes so you know how to plug them back in later)
- Remove 2 screws on the hotend that holds the heatsink on
- Loosen Bowden coupler on the hotend and slide it off the tube
- Remove the 2 remaining screws on top of the hotend
- Feed bowden tube and corrugated tube through the hotend adapter. Feeding the wires through at a 45deg angle
- Tricky part; You now need to push the bowden coupler back on the tube. You need to use a small piece of tube and push on the other side of the coupler to get it to go in.
- Tighten harness piece on
- Place corrugated plastic wire tube in the harnes and the adapter and tighten all 4 screws to hold the wires in place
- Finish sliding coupler on.
- Use wrench to tighten the bowden tube couple onto the wire harness
Category: 3D Printer Parts