Mix and Match Coaster Set

Since doing some redecoration to my living room, decided to make a unique collection of filament paintings (hueforge), base and holder to create your own unique coaster set. My choice was one of each but you can mix and match to create your own favourite set.

The holder can hold up to 6 coasters. For each coaster you will need to print one base and glue them together with a super-glue.

Coaster Base / Coaster Holder

Print these with 0.20 layer height and about 10-15% infill. You will need to print one Coaster Base for Each Coaster and one Coaster Holder

Filament Paintings

All Hueforge/Filament Paintings, you can print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm and use a tight brim to keep them on printer table and avoid wrapping.

Microworld

Filaments Used:

• PLA Overture Black
• PLA+ Sunlu Gray
• PLA Overture Light Gray 
• PLA Overture White

Swap Instructions:

• Start with Black
• At layer #5 (0.48mm) swap to Gray
• At layer #10 (0.88mm) swap to Light Gray
• At layer #16 (1.36mm) swap to White for the rest.

SpiderWeb

Filaments Used:

• PLA Overture Black
• PLA+ Sunlu Gray
• PLA Overture Light Gray 
• PLA Overture White

Swap Instructions:

• Start with Black
• At layer #4 (0.4mm) swap to Gray
• At layer #10 (0.88mm) swap to Gray
• At layer #17 (1.44mm) swap to White for the rest.

Faces

Filaments Used:

• PLA Overture Black
• PLA+ Sunlu Gray
• PLA Overture Light Gray 
• PLA Overture White

Swap Instructions:

• Start with Black
• At layer #5 (0.48mm) swap to Gray
• At layer #10 (0.88mm) swap to Light Gray
• At layer #18 (1.36mm) swap to White for the rest.

Robot Face

Filaments Used:

• PLA Overture Black
• PLA+ Sunlu Gray
• PLA Overture Light Gray 
• PLA Overture White

Swap Instructions:

• Start with Black
• At layer #5 (0.48mm) swap to Gray
• At layer #9 (0.88mm) swap to Light Gray
• At layer #16 (1.36mm) swap to White for the rest.

Smile

Filaments Used:

• PLA Overture Black
• PLA+ Sunlu Gray
• PLA Overture Light Gray 
• PLA Overture White

Swap Instructions:

• Start with Black
• At layer #6 (0.48mm) swap to Gray
• At layer #10 (0.88mm) swap to Light Gray
• At layer #17 (1.36mm) swap to White for the rest.

Mouth Kiss

Filaments Used:

• PLA Overture Black
• PLA+ Sunlu Gray
• PLA Overture Light Gray 
• PLA Overture White

Swap Instructions:

• Start with Black
• At layer #6 (0.48mm) swap to Gray
• At layer #10 (0.88mm) swap to Light Gray
• At layer #15 (1.36mm) swap to White for the rest.

Enjoy my work? Support me by joining my club. Tier 1 offers exclusive models, while Tier 2 allows you to sell my 3D printed artwork.