35mm Slide Sample Cards x60 Rugged Box (Prusa Mini/+)

This is the “Rugged Box v3 60” for 35mm Slide Filament Samples (and also fitting my remixed 35mm Slide Infill Samples) cut down to fit the bed of a Prusa Mini/+ or other smaller printer. There is also the option of a windowed top, so you can see the slides inside even if you print with opaque filament. You could probably even use this box with actual 35mm slides, though they might rattle a little. (The swatches are 50.8mm x 50.8mm x 2.0mm. Typical 35mm slides are 50mm x 50mm x 1.8mm, but dimensions can vary, so please reality-check your measurements vs. the box before printing for use with anything but these specific sample slides.)

You will need:

• One top:
  • Solid; OR
  • With the same windows as the “Classic Box” design, so you can see the swatches inside (note that this makes a seal particularly useless)
• One bottom
• One set of latches (one file contains both latches)
• Optional: One seal, to be printed in TPU
• Hardware: 6 x M3x30 screws

Once you've printed all the parts, use:

• Two screws as the two hinges connecting the top and bottom (at the back of the box);
• One screw for the top of each latch to connect it to the front of the lid; and
• One screw across the each set of holes on the front of the bottom of the box, for the latches to snap onto.

You can orient the screws however you want, but it's easier to screw them in if you point them inwards.