Surge Protector Mount - Buttonhead Screw or Bolt
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Surge protector mount, with a 1.5" wide x 1.25" tall opening. Will fit between outlets spaced 0.5" or more apart.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 33
- Makes
- 0
- Views
- 194
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial
Surge protector mount, with a 1.5" wide x 1.25" tall opening.
Will fit between outlets spaced 0.5" or more apart.
There is a hole on each end, that should accept up to #8 (5/32") screws or bolts.
Print on side, for best results. No supports needed. Any material you want.
My settings…
PLA
Layer lines: 0.2mm
Line width: 0.4mm
Wall count: 3 ea
Top/Bottom layers: 4 ea (for extra structural support)
Infill: 10-25% (it needs to retain a little flexibility for if surge protector is SLIGHTLY larger)
Infill pattern: anything
Build plate adhesion: brim (to relieve cooling strain on sharp first layer angles)
I hope this helps you. If it does, please give it a comment and a like!
All constructive criticism and suggestions are welcome!