Revolving USB/SD-card organizer
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
In the end of 2022, I was contacted by a company that asked if I wanted to make a contribution in the form of a design..
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 34
- Makes
- 0
- Views
- 204
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
In the end of 2022, I was contacted by a company that asked if I wanted to make a contribution in the form of a design. I thought about it, and as usual I wanted to make something I needed myself. I do have a lot of USB-drives, SD-cards, USB-gadgets etc. so I decided that I wanted to make a unique USB and SD-card holder.
My goals:
- Should be unique.
- Should take many USB or SD-cards.
- Should use as little material as possible.
- Should be somehow easy to print (not too demanding).
What I ended up with is a 6 sided holder, with 8 slots on each side. All slots can take either an USB device, or a standard size SD-card. To make all devices easy to access, I also made it revolving and with an option to use a 628 bearing to make it spin even better.
If you have an 628 bearing, print the “stand w bearing”. If you do not have that, or just don't want to use it, print the “stand no bearing”. In both cases, you do need the “USB SD storage final”.
I did my test print of this in PETG and found the bearing fit a bit tight, so I increased the diameter of the bearing area from 19.00 mm to 19.15 mm in hope that it should work fine with PLA as well.
Don't forget to post your makes!