Rear derailleur jockey wheel
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Rear derailleur jockey wheel compatible with Shimano Deore RD-M592 rear derailleur. Probably compatible with many more.
- Rating
- 4.75 / 5
- Likes
- 69
- Downloads
- 301
- Makes
- 4
- Views
- 1,650
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Share Alike
Hello everyone, long time no see. Today I bring you a 3d model of a MTB Shimano rear derailleur, model RD-M592. This wheel is compatible with many more derailleurs, even from other brands.
Nevertheless, here are a few important notes:
I printed it in standard PLA over a year ago and it already survived more than 500 km. I do not think it would survive a long time exposed to UV radiation and heat.
There is an attached picture after application (new). And current state (don't mind the mess).
After printing, i sanded a bit of the inside hole to better accommodate the steel sleeve, as it does not have a bearing in it.
I also sanded the outer sides of the engaging teeth to not get stuck in the chain links. I printed it with concentring layers, 6 wall lines and 30% infill (I think as I don't have the file with me right now).
Even with that 5 min sanding, I did not make changes to the model as different printers could induce other problems. (My printer is not that good)
I propose to use a drill bit with the same diameter as the inner steel sleeve to enlarge the hole to de correr dimensions, if it doesn't fit properly.
You, MTB'ers out there, put a little of grease in that thing to reduce heating from friction.
Any question, feel free to ask.