Camera Lens Cap 58mm
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a 3-D printable lens cap for a 58-millimeter camera lens.
- Rating
- 4.5 / 5
- Likes
- 51
- Downloads
- 838
- Makes
- 3
- Views
- 2,824
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Photo & Video
- License
- Creative Commons — Attribution — Noncommercial
Both pieces need supports . It should take less than an hour and a half in total. For the settings keep reading, for the story skip down below. The assemble it make sure all supports are cleared and slide the end without the ridges under the overhangs, then squeeze the ring and do this for the other side.
20% infill
0.2-layer height for main piece
0.12-layer height for ring
Gyroid infill
200 temp.
sunlu PLA filament
Supports: yes
The story:
I recently got out some old camera supplies and I couldn't find one of the lens caps, then as I look on pintables for a replacement (spoiler, I couldn't find one) I noticed the replacement parts competition and thought, this would make a good replacement part. This cap not only works for a replacement part, but for customization as well. Pretty much all camera lenses are black so it's fun to spice them up every once in a while. (I include a ”smile“ cap for fun) 19 test prints later I got a working model. Both are made out of PLA because it mimics the flexibility of a Cannon lens cap ring. Also I you wanted to put something on the lens you could totally do that.