QIDI X-Plus X-Max Top Cover

Update April 1, 2021

Added a version without filament guide. Use this version if you just want to cover the hole in the top cover:

qidi-xplus-xmax-top-cover-no-guide-1.0.stl

About

This is a remix of Elmagnifico666's excellent "Qidi XMAX snap-on filament guide". The objective is to cover the hole on top of the acrylic cover, enclosing the printer fully.

This version has sturdier structure, especially at the top of the cover and around the filament guide where the black filament tube goes, I've also added some chamfers here and there for stability. Also, the middle part is a bit slimmer for faster printing/less filament usage.

To use, just snap it in. Then insert the black 6 mm tube that comes with the printer and guide the filament through it.

Support

All my designs and mods on Printables are free to use and remix. They have a non-commercial license. If you enjoy this or any of my other designs you can send me a small donation using the link below. Thanks :)

https://www.paypal.me/humebeamengineering

Print Settings

Printer:

QIDI Tech X-Max

Rafts: 

No

Supports:

Yes

Resolution: 

0.16 mm

Infill:

25%

Filament: Fillamentum ABS Black 

Notes: 

Print it in the direction I have set it. Depending on how well tuned your printer is, you may or may not need supports. Lowering the layer height will improve overhangs, I usually print 0.16 mm layer height. To be on the safe side, it may be best to place some supports below the angled area leading up to the filament guide hole.

Remixed from:

https://www.thingiverse.com/thing:4591310