OP3D RC Snowmobile light add-on
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
3D printable light add-on for my open source 3d printed rc snowmobile
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 33
- Makes
- 0
- Views
- 488
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Share Alike
This is an add-on for the OP3D RC Snowmobile project. A fully open source 3d printed rc snowmobile. You can find the project here: https://www.thingiverse.com/thing:4710124
As for this add-on it uses 5mm led lights. 2 regular ones for the front and 2 red ones for the rear. I just split the cables from my 7.4 volt lipo battery and connected them using dupont connectors but of course you could configure brake lights and on/off if you want.
There are two mounts for the front that you have to glue on on the front shock mount and two that go in the rear. They also have a small extra part that you can add if you want to. I think it looks a better but I had to make it a separate part for support reasons.
Assembly video: https://www.youtube.com/watch?v=8GiCS329wf8
The front lights have to be "layed flat" in the slicer because thay have an angle on the side facing down. If you go to rotate and then lay flat they will rotate perfectly. In cura it's in the left under rotate. You have to have the model selected.
As you can see on the video these lights do look great in the dark and the look even better if you see them yourself. If you've build the snowmobile you should really give these lights a go. It's quite simple and looks great!
Want to support my work: https://paypal.me/3Drcnc
Happy printing! /3Drcnc