Prusa i3 MK3S LCD supports (short)
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€1.30 – €1.59 net (excluding VAT)
For file: lcd-supports-short_02mm_petg_mk3s_1h33m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €1.44 excluding VAT (range midpoint).
- Weight reported by the author
- 17 g
- Print time reported by the author
- 1.55 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
LCD support arms for the Prusa i3 MK3S that are 11mm shorter than the stock models, making the LCD panel protrude only…
- Rating
- 4.929 / 5
- Likes
- 105
- Downloads
- 1,049
- Makes
- 30
- Views
- 4,485
- Reviews
- 42
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- GNU General Public License v2.0
LCD support arms for the Prusa i3 MK3S that are 11mm shorter than the stock models, making the LCD panel protrude only as far forward as the heatbed can travel.
This reduces the footprint of the MK3S and saves space in tight enclosures.
Note: On extended use I have noticed the casing for the LCD panel has started to slightly bow outwards through heat from the heatbed, now the bed passes over it more. This has had no impact on printer functionality so far but it may be prudent to avoid this modification, use an LCD panel case made out of a more temperature-resistent material, or print on the front of the bed to avoid it hovering over the LCD display too often, if you tend to print using high-temperature filaments.
Print instructions
The attached 3MF and GCODE files are set up to use PETG at Prusa's recommended print settings. Swap for the stock parts (remember to swap the square M3 nuts as well) and then test range of motion of the heatbed in your enclosure manually when powered off, to ensure unrestricted movement is still possible.