1 / 6
Dremel 4250-4300 Holder with separate cable rack for Honeycomb Wall — image 1
1 / 6

Dremel 4250-4300 Holder with separate cable rack for Honeycomb Wall

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Dremel 4250, 4300 Holder for Honeycomb Wall and some cable management for it. May fit another models as well.

Rating
5 / 5
Likes
71
Downloads
326
Makes
2
Views
1,660
Reviews
2

Updated at source:

Model information

Category
Organizers
License
Creative Commons — Attribution — Noncommercial — Share Alike

Holder for Dremel 4250 to be fitted on Honeycomb wall. Probably will fit another models like 4000-ish or 3000 but that's not for 100% sure. I Made a separate rail for cable as well. made from 2 parts. Not sure why, but just liked the idea. And separate cable locking piin to be put anywhere you want on the wall. After some test i found that this Dremel holder is sturdy enough so You can even use it in holder if you have a flexible shaft. Only thing as I didn't design it for that purpose, probably Dremel will heat up as there are no vents in holder. So a bit later I will make a new version with them as well.

Supports needed only for cable Holder bracket. As on Picture best placements on bed when slicing are standing on inserts or lying on side. I used second variant with tree supports and it did printed fine. only a bit harsh to get supports out from sliding rail. Just took a hobby knife and cut them from both sides (walls) and they should tear then off easy. 

 

You can Buy me a coffee if You feel good doing so :) (And very big Thank You For interest in my work)
https://www.buymeacoffee.com/warlogh

Tags