Halloween Pumpkin with flatter base and thinner lid
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remix of UserS' Halloween pumpkin to have a flatter base and thinner lid
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 86
- Makes
- 0
- Views
- 353
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Autumn & Halloween
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I was looking around for a Pumpkin lantern to print for Halloween and really liked UserS' one, but I had to split it into two separate models so it would fit into my 220mm square print area.
While I had the model in Tinkercad I decided to make a couple of alterations, the first was to shave some layers off the base so it didn't need supports in that area, and to add a 30mm flat internal area to stand a LED tea light. While I was at it, I also shaved some off the lid as it seemed unnecessarily thick to me, and I figured that would save material and print time.
I printed it using Amazon Basics Neon Orange filament (which is slightly translucent) at 0.2mm layer height.