1 / 2
Compressed Air Hose Pass-through Grommet
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A simple two-part grommet for passing a compressed air hose through 3/4" plywood material
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 26
- Makes
- 0
- Views
- 221
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution
Not a whole lot going on with this model. It's two mating parts, one on either face of a piece of ¾" / 23/32" / 19mm plywood. It should be large enough internally to feed the male connector end through. I used a bit of CA glue to connect them. The hole size needed in your material is 7/8".
Print in original orientation with no supports. Takes about 10 minutes to print both parts at once.