Gold Series XY joiners with clamping mod for Rat Rig 3/3.1 printers.
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Improved Rat Rig V-Core 3.1 XY joiners. Note this version of the mod is for the 3.1 upgrade of the V-Core 3 only. The…
- Rating
- 0 / 5
- Likes
- 11
- Downloads
- 46
- Makes
- 0
- Views
- 475
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
Update: I highly recommend using my new VC3 & VC3.2 hybrid upgrade joiners rather than these ones, even if you have no intention of upgrading to full hybrid mode. The new ones are MUCH more rigid than the original Rat Rig ones and these gold series ones.
https://www.printables.com/model/902728-rat-rig-v-core-31-hybrid-upgrade
Improved Rat Rig V-Core 3.1 XY joiners.
Note this version of the mod is for the 3.1 upgrade of the V-Core 3 only.
The standard joiners use the bolts that act as the axles for the bearings stacks to clamp the XY joiners to the alumimium plate.
This mod also uses the cap screws that hold the aluminium extrusion into the the printed XY joiners to also clamp the XY assembly to the aluminium plates. This is probably overkill but provides a slightly more rigid assembly at no extra cost.
These XY joiners also have the front and rear overhangs removed for a cleaner look.These XY joiners also have the front overhangs removed for a cleaner look. This makes them easier to print standing vertically. I like to print these vertically to get a flatter/truer base and more perfectly aligned axle holes.
This also gives them more clearance to the top plates of the front idler tensioners if your are using them with the OneBox OpenFront design, which is nice to have.
BOM
The original two bottom 10mm long cap head screws that hold the aluminium X gantry into the XY joiners need to be replaced by 25mm cap head screws.
Coffee fund
If decide to make a donation to my coffee fund (which keeps me up late at night doing more of this stuff) I would appreciate it. There is absolutely no obligation for you to do this. My PayPal account is [email protected]
Please remember to post feed back as it is always valuable to me for future iterations.
Many thanks.
Liam Venter
MFBS Design
Attribution:
These are a derivative of the Original Rat Rig V-Core 3 XY joiners.
Print Settings
Printer:
OneBox
Rafts:
No
Supports:
Yes
Infill:
30%
Filament: Any PETG, ABS, ePA6-CF
Notes:
To use. you will need two longer cap screws (5mm diameter x 25mm length)at the bottom on each side. These replace the two shorter ones that do not pass through the steel plate with the standard design.
Insert the two longer screws through the steel plate and use the tension on these to provide the clamping force between the new printed part and the steel plate.
Now you can set the tension on the bolts that pass thru the idlers. This tension should be just enough so that you can still freely spin the two plane idler spacers but are not loading the bearings in the idlers.
Category: 3D Printer Parts