Parametric corner cable holder (90degrees)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
90 angle bend cable holder
- Rating
- 4.933 / 5
- Likes
- 2,232
- Downloads
- 3,085
- Makes
- 19
- Views
- 12,503
- Reviews
- 15
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Introduction
Inspired by "Cable Corners... keep cables in corners!" by muzz64 on Thingiverse
Fusion 360 parametric design
This is for bend-sensitive cables, such as Cat 6 and Cat 6A. In the case of these cables, the curvature of the bend is defined by the cable outer diameter. For instance, I use Cat 6 cables by FS.com with an outer diameter of 6.2mm. The bend radius is therefore 4✕6.2mm = 24.8mm.
Enjoy your neat cables.
Printing it
Easy! Print flat on the bed. No supports, no worries.
I've uploaded 1 and 3 cable versions for 6.2mm OD cables.
Customisation
Download the F3D (Fusion 360 archive) file and open in Fusion 360. Choose “Modify > Change Parameters" and change the parameters to suit your requirements. Most users will only need to adjust the CableOD and CableCount parameters.