Mjx hyper go rear shock tower
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Rear shock tower for mjx hyper go print at 100% In fill
- Rating
- 0 / 5
- Likes
- 19
- Downloads
- 329
- Makes
- 0
- Views
- 1,237
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial
Rear shock tower for mjx hyper go print at 100% Infill, pla should be fine the holes for the upper suspension arm screws might need drilling out to 2.5mm after printing this was a requested part by @SamHammes_1124827 here on printables I haven't had a chance to test durability as of yet but should be as good as the original part
v1 is for the hyper go 16207
v2 has body mount holes and should fit most other models and also has .5mm bigger screw holes (this one has 1.5mm thickness for 5mm mounting screws)
v2.5 is the same as v2 but has thicker (3mm) part where the screws hold to the diff id recommend trying this one first and if your screws arnt long enough print v2