1 / 7

Slim front side AMS (and Hydra) narrow side corners silica dryer pod/drybox with snap fit lids for Bambu Lab AMS

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

eds_3d_shop

@eds_3d_shop

With this slim silica box you can put two more boxes with snap-fit lid on the front side corners of AMS!

Rating: 4.962 / 5
Likes: 751
Downloads: 13,524
Makes: 31
Views: 22,935
Reviews: 26

Updated at source: Sep 23, 2025

Model information

Source: Printables
Category: Bambu Lab Parts & Upgrades
License: Creative Commons — Attribution — Noncommercial — NoDerivatives

Details Files (3)Makes & comments (Makes: 31) (Comments: 77)Remixes (0)Collections (659)

UPDATE 1.02.2024:

I think the silica boxes in AMS are simply brilliant, so the filaments can stay in AMS for a long time and be kept dry for a very long time! The silica gel can simply be dried in oven or microwave and used again - top!

When changing silica, I wondered whether boxes should also exist for the narrow sides/corner niches on the far left and far right in AMS? I discovered a few models at printables, but they did not fit the design of my existing ones, did not have a "snap fit" lid, or grid was so oriented that they could not be printed cleanly. So, I allowed myself to remix two models - that's what it's all about!

These side boxes are fully compatible with the Hydra AMS! (proved by Hydra Users)

Print Instructions: (important changes for this filigrane model)

Quality:

layer height: 0.15mm

Strength:

wall loops: 2
top shell layers: 5
bottom shell layers: 3
sparce infill density: 20%

Speed:

first layer: 20 mm/s
first layer infill: 20mm/s
outer wall: 50 mm/s
inner wall: 50 mm/s
small perimeters: 50%

Others:

Brimtype: outher brim only
Brim width: min 5 mm

This model should be printed slowly and needs maximal cooling for nice finish of grid - better place them close to AUX Fan and set this (after first 1-4 layers) to 70%.

It is helpful to swith your Bambulab Printer from “Standard” Speed to “Quiet”!

Filament: PLA is good enough!

— ! —

Thanks in advance for downloading and please don't forget to like this model!

Take a look at my other very helpful models for X1/P1P/P1S: