Ikea LACK Enclosure Honeycomb Trim Kit
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Some trim pieces for sealing up the gaps between the LACK parts and the enclosure walls.
- Rating
- 0 / 5
- Likes
- 12
- Downloads
- 51
- Makes
- 0
- Views
- 585
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
These are some simple trim Pieces to use around the edge of each of the wall panels in an Ikea LACK or LACK-Stack enclosure. These don't protrude too far into the enclosure, so they should not interfere with the printer or any of the wiring.
These are done in the same honeycomb pattern as my Forfuntig Filter frame(https://www.printables.com/model/593213-ikea-fornuftig-frame), hidden hinge remix () and Enclosure Widebody Extensions().
If using a .120 enclosure wall (acrylic, ABS or others), you will need to also use 12m taper head m4 screws and hex nuts for these. The Hex nuts should press in by hand, but if they are stubborn, they can be pulled into the part by using the screw. If you are using something like a .093 or a .125 you will have to adjust the screw lengths accordingly. I recommend printing a few test pieces and doing a fit check before committing to a full print.
Depending on how you use these, there are L-Brackets, flat brackets, support, and seam pieces (in case you do not have a wide enough panel and have to use more than one piece of material to make a full panel).