Skullcandy Crusher Evo headphone replacement arms
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.08 – €0.10 net (excluding VAT)
For file: CCR10_evo arm limiter v1.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.09 excluding VAT (range midpoint).
- Weight reported by the author
- 1 g
- Print time reported by the author
- 6 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
its a simple replacement part for the skullcandy crusher evo headphones, very easy to install, easy to print.
- Rating
- 0 / 5
- Likes
- 15
- Downloads
- 136
- Makes
- 0
- Views
- 1,728
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Audio
- License
- Creative Commons — Attribution
This is a simple replacement arm i built for my wireless Skullcandy Crusher Evo headphones. the mod is very easy to install, just pop the old arms out with a screwdriver and the new ones should fit in just fine, it goes in the same way that the factory arm does. The limiter print is not necessary, and uses some standard small electronics screws that are about the same size as the headphones screws, the limiter does help prevent damages from happening if somebody tried to rotate them around the hinge too much.