Bottle Dryer Extender
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€1.15 – €1.40 net (excluding VAT)
For file: Bottle Dryer-extender_1h41m_0.20mm_240C_PETG_ENDER3V2NEO.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €1.27 excluding VAT (range midpoint).
- Weight reported by the author
- 8 g
- Print time reported by the author
- 1.68 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
I loved this bottle dryer but it wasn't tall enough for the LTT water bottles that my wife and I use so I made this!
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 13
- Makes
- 0
- Views
- 133
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Public Domain
I made the extender by sinking the original in to the build plate and then increasing it's size. Next, I took the original and used it as a negative volume to empty out the inside so it can just friction fit on top. I did find that it was super tight though so I then increased the size by a little bit again so it should be good for all printers.
I used both PETG for the original piece and the extender