PicoPad - Macro pad with encoders and choc switches
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A 3x3 macro pad with two rotary encoders, Kailh choc switches, and a raspberry pi pico
- Rating
- 0 / 5
- Likes
- 11
- Downloads
- 69
- Makes
- 0
- Views
- 1,412
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- GNU General Public License v2.0
A simple macro pad that uses Kailh low profile choc switches, two rotary encoders (optional) and a pi pico. An example KMK firmware can be found on Github.
The rotary encoders are optional. I have the pico flipped so that you can add any kind of accessory to the top of it, oled/encoder/leds/fidget spinner/etc. This is a hand wired keyboard so you'll have to solder the wires to the switches and then to the pico. There are no matrix multiplexing/diodes on the switches. Each switch is wired directly to ground and to a gpio pin. Take a look at the github code for example gpio's used.
Printing tips:
To fit the chock switches tightly, make sure to set “elephants foot compensation” on prusa slicer to 0.3mm. Elephants foot on the switch_plate.stl will reduce the hole perimeters where the switches enter which will result in you taking a scalpel/de-burring tool to every perimeter edge of the print to fit the switched. Ask me how I know… So make sure to have this setting enabled.
If you're adding the encoders, I suggest printing the cover separately and enabling ironing to get a better surface finish like I had.
I've used Bull3t's keycaps.
If there are any questions, don't hesitate to ask.
Happy Printing :)