Tupolev Design Bureau
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
An easy two color print of the Tupolev Design Bureau's old logo
- Rating
- 0 / 5
- Likes
- 18
- Downloads
- 91
- Makes
- 0
- Views
- 578
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- 2D Plates & Logos
- License
- Creative Commons — Attribution — Share Alike
I was browsing the internet, looking at logos of old aircraft manufactures and wanted to see if I could recreate some of them. The finished print is approximately 100mm(3.75 inches) wide and 90mm(3.5 inches) tall.
Print instructions:
This can be printed easily without the MMU2 since the color changes occurs at a specific layer. I printed it in PETG, but PLA would work just fine too.
Parameters that I used were .15 layer height, 15% infill, 5 solid layers top/bottom and ironing on all top surfaces.
Just add a color change in Prusa Slicer where the print transitions from the blue base to the white details.