1 / 5
Replacement Cord Hooks for Hoover Wind Tunnel Vacuum UH72600
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Public Domain
Over the past few years I have managed to break both cord hooks. So I just made new ones! These have been in service for awhile and are working fine.
They should load up in the intended printing position and do not require supports.
The top hook was printed with a firm 98A tpu (Priline). Very possible that PETG or PLA may work but have not tested that. It rotates to release the cord just like the original. I like the firm tpu because it is very tough and can handle a tip-over impact without problem.
I used PLA for the bottom hook.