Billfold Clip / Money Clip
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replacement clip to go into a billfold, or be used as a basic money clip on its own (I use the original both ways).
- Rating
- 0 / 5
- Likes
- 12
- Downloads
- 116
- Makes
- 1
- Views
- 682
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution
This is a replacement clip to go into a billfold/wallet, or could be used as a basic standalone money clip.
I have printed this both directly on the print surface and slightly raised, as the main shaft is round. Either way is fine for printing.
However, as the clip part is at the center of the shaft, it will require some support.
I would suggest a zig zag support, at 20-25% infill.
Main infill can remain at minimal levels (20-25%), that are just enough to support the top layers.
Wall count at 3, to provide sufficient strength to both the shaft & clip.
NOTE: I have printed this directly on the build plate, 0.5 mm off the plate, and 1 mm off the plate. I have had the best success with removal of supports, when the part is at the 1 mm elevated position. At this elevated location, the support separated as a single piece, where the others had it in multiple pieces.
If you have any suggestions or insight, please provide and I will try to implement in an updated version.