NanoLineLock
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A tiny line lock for very thin paracord and elastic.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 21
- Makes
- 0
- Views
- 199
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution
I use a fair amount of 2mm elastic in DIY gear, for snugging down shorts, cuffs, hoods, etc. Reliable line locks for that size are hard to find. This one is small, light, and foolproof. No springs to break, a single piece, and simple to print. Run the doubled line as shown and it will slide with gentle pulling in either direction. To lock, pull the exiting line into the keyhole loop.
If the size is a little off for your cord, just scale these one way or the other.
Print Settings
Printer Brand:
Prusa
Printer:
i3 MK3
Rafts:
No
Supports:
No
Resolution:
20
Infill:
100
Filament:
Inland PLA
Notes:
I printed these with the red PLA that was in the printer. I'll probably do more in black PETG. Prusa Mini, 0.20 mm height printed fine, even the little keyhole overhangs.
Category: Outdoor & Garden