1 / 2
Swing arm mount for Acer S220 monitor — image 1
1 / 2

Swing arm mount for Acer S220 monitor

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Simple wall mounted swing arm mount to replace factory pedestal mount of an Acer S220 monitor

Rating
0 / 5
Likes
1
Downloads
25
Makes
0
Views
330
Reviews
0

Updated at source:

Model information

Category
Computers
License
Creative Commons — Attribution — Noncommercial

They say necessity is the mother of all inventions.
I needed a pivoting mount for a monitor on my reloading bench. 
I came up with this design to fit my needs. 
It has two different monitor mounts. 
The file labeled monitor_mount_HR.stl raises the height of the monitor to allow it to swing 360 degrees, on the swing arm. The monitor_mount.stl will contact the swing arm not allowing complete rotation of the monitor.
The holes on the monitor mount are M3 and they are spaced 1.125inches between center. This is the spacing on the ACER S220 monitor that I am using but other monitors may be compatible. If these holes are compatible for your monitor there is a blank side on the monitor mount that you can create your own holes.

 

The swing_mount.stl is secured to the wall with #6 screws. I used #6 x 1.25 inch long sheetrock screws.

The swing_arm.stl is attached to the swing_mount.stl with two ¼-20 x 2.5in long hex bolts. These bolts thread directly into the swing_mount.stl. If you don't like the idea of threading into the plastic a 1/4in piece of allthread and some nuts could be used in place of the ¼-20 bolts.

Printed with my standard PLA settings with 25% infill and supports from bed only.

All parts were placed with their flat surfaces on the bed so only a minor amount of support is required when printing the hinge points.

 

 

 

Tags