1 / 13
Voron V0 / V0.1 / V0.2 (R1) PicoBilical main plate strain relief — image 1
1 / 13

Voron V0 / V0.1 / V0.2 (R1) PicoBilical main plate strain relief

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A Simple Mod to Help your Printer!

Rating
5 / 5
Likes
24
Downloads
89
Makes
1
Views
834
Reviews
1

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

After having a go at designing a Stain Relief for the PicoBilical I came to the realisation that not a lot of people want to change the Main Base Plate.
I don't blame you, it is rather fiddley and requires quite a bit of work.

So I came up with this design.
It is simply Glued into / onto your existing Main Base Plate.
No screws
No heatset nuts

My aim is to reduce the Strain on the Connector as these will Flex while printing and result in part failure.
This Mod Stops that Flexing and helps to keep you running for longer!

For the best results use with this tool head strain relief…
https://www.printables.com/model/620904-voron-v02-r1-umbilical-strain-relief-super-light


the main goals were…

  • easy installation 
  • quick easy print
  • “no loss” cable tie (you only need one… ever!)
  • easy access to the connector clip

once you have printed all the parts and test fitted them to make sure your happy with the fit, its time to get gluing!

part 1.
Spread glue in these locations and press the collar into place. (this helps to locate the strain relief adapter into the Main Base Plate)
wipe away any excess glue, clamp and leave to set for a few minutes.

part 2.
Spread some glue in these locations.
these are the faces that will bond with your Main Base Plate, if you can clamp it in place and leave to set for a while.

once that is all done we can now move on to the final part.
the Cable / Loom clamp has a channel through it for a 2.5 x 1.4 x 100mm cable tie (the ones we use for the Mini SB)

push the umbilical connector onto the main board.
now loop the cable tie through the channel and round the cables but don't tighten it up just yet, just make sure its started tightening.
slide the Cable Clamp onto the two locating pillar's and then secure the cable tie.

Don't Glue this last piece as it is designed to stay with the wiring loom / Umbilical cable.

you can still remove the Umbilical as and when needed and the Strain Relief with just slide off its locating pillar's. 

I printed this with standard Voron Settings

4 perimeter walls

5 top / bottom layers

40% infill

PLEASE BE AWARE THAT THIS IS A PROTOTYPE AS I PERSONALLY DONT HAVE THE PICOBILICAL ON MY V0.

UPDATE REV 1.1

  • Small update to some part size and tolerance adjustments.


Any feedback would be more than welcome to make this mod more user friendly!

as always… Happy Printing!

Tags