1 / 3
Collapsible print-in-place door stopper
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Can be fixed to the door using double sided tape and folds away when not needed
- Rating
- 5 / 5
- Likes
- 114
- Downloads
- 257
- Makes
- 1
- Views
- 2,829
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution
Print instructions: Single model print-in-place. Tested with 0.20 and 0.25 layer height.
Setup:
- Pull out the stopper block and put it under the door as desired
- Mark the location where the Plate can fit without stretching the pins
- Use a command strip or any double-sided tape to fix the plate to the door
You could add couple of holes for nails on the plate but I didn't want to punch holes in my door. Feel free to remix the obj file if you choose to
Tip: I personally found 75% scaled down model was enough for my door, saving some material and time