1 / 1
Hollowed out lids for Vase mode Jack-o'-lantern — image 1

Hollowed out lids for Vase mode Jack-o'-lantern

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Print thin pumpkin lids to let the light through

Rating
5 / 5
Likes
22
Downloads
164
Makes
1
Views
651
Reviews
1

Updated at source:

Model information

Category
Home Decor
License
Creative Commons — Attribution — Noncommercial — Share Alike

This is a beta, early, last minute modification for Halloween 2023 - printing successfully will require you read the advice below - but I wanted to get this up for you last minute 2023 pumpkin printers.

I love Daniel Josvai's vase mode design - Ive printed 6 now at 3 scales over the last few days, but the lack of light transmission through the lid is a small issue. To solve it, I remixed the lid, removing the bottom surface and then solidifying the remainder to 1.2mm

1.2mm thickness was required as my tests at 0.8mm left the lid a little too thin in places, but 1.2mm seems to get the job done.

There are 4 versions of the lid, 50%, 100%, 150% and 200% size. Ive printed 50,100 and 150 so far with the settings below. the 200% size is untested.

To print 

Be aware Im rushing these up for halloween 2023 - the thickening process has meant the bottom is not level, so sink your model a layer or two before slicing, for an even bottom layer.

Print at 0.6mm line width and 0.2 layer height for success - but feel free to experiment - a 0.8 line width ‘may’ work on this model - I havent tried it. 

Support is essential. For support I recommend lines, with no top, bottom or side supports, just the lines - so if you have to, you can leave the support in place and light will still transfer through the lid. I used 10% support density and 55% overhang. I recommend you test your support settings on the 50% version which will only take 15 mins to print.

 

Tags