1 / 1
Troodon 2.0 Rocker Feet
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remix of Voron Rock & Roll feet that allow easy access to the electronics of the Troodon 2.0
- Rating
- 5 / 5
- Likes
- 5
- Downloads
- 75
- Makes
- 1
- Views
- 608
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Public Domain
These make accessing the electronics of the Troodon 2.0 much easier.
Required hardware:
- 4x M4x10mm socket head cap screw
- 6x M4x16mm socket head cap screw
- 10x M4 spring-loaded t-nuts for 20x20 extrusion
Installation steps:
- Remove the trim pieces from the rear corners of the printer.
- Remove the bottom screw & t-nut from each side of the plexiglass back.
- Drill the bottom hole on each side of the plexiglass back out to 4.5mm or 11/64 inch.
- Place spring-loaded t-nuts in the aluminum extrusions for each screw location.
- Fasten the feet in place using 10mm screws on the sides of the printer and 16mm screws on the back.
I've included 2 stl versions, one with additional ears on the model to help bed adhesion and one without.
The model is designed to print at .2mm layer height. I used 5 layer (2mm) wall thickness and 35% triangle infill.
I used red Overture PLA+ filament. It isn't a good color match for the existing printer trim.