Woody's Beard Oil Transfer Device
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A small device to connect two bottles of Woody's Beard Oil together to transfer the remnants from one to the other.
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 28
- Makes
- 0
- Views
- 190
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Bathroom
- License
- Creative Commons — Attribution
Connect two bottles of Woody's Beard & Tattoo Oil together to allow the remnants of one to drain into the other. Never waste a drop of that precious beard oil again!
Printing:
Print with the “cone” shape of the internal funnel facing up (like so: / \ ). Paint-on supports are necessary on the side facing the print bed (shown in the screenshot to the right). Use of organic supports is recommended. The supports can be a little tricky to remove, but a small pair of needle-nose pliers makes quick work of it.
Use:
Thread the connector onto the new bottle with the internal funnel right-side up (so it will funnel the oil into the new bottle). Turn the old bottle upside-down and thread it into the other side of the connector. Leave the bottles in this orientation on your counter for a sufficient amount of time to allow the last of the oil in the old bottle to drain into the new bottle. After the old bottle is drained, remove the old bottle from the connector and discard. Remove the connector from the new bottle, replace the eyedropper/cap on the new bottle and rinse the connector clean before storing.