MK3.9/MK4 X-Motor Cable Strain Relief
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
90-degree strain relief for the MK3.9/MK4 X-motor cable to better support and reduce flexing of the wires at the motor.
- Rating
- 5 / 5
- Likes
- 31
- Downloads
- 136
- Makes
- 5
- Views
- 677
- Reviews
- 5
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution
Because the MK3.9/MK4 now positions the X-axis motor cable at the top of the xBuddy box, this 90-degree strain relief bracket minimizes the flex point of the wires not covered by the textile sleeve and secures the sleeve at it leaves the stepper motor to distribute the flex across the whole cable assembly.
The print requires only a couple small points of support as shown in the picture. These are easily painted on with support enforcers, and snug supports work well with minimal waste.
Assembly requires 2x M3x10 screws and 2x M3n nuts from the spares kit. If the nuts are a little snug, you can use the “screw pulling technique” to seat them before assembly.
The example was printed in Prusament PETG with a 0.4mm nozzle using the 0.20 Structural profile.