Inline Fabrication Rail-Mounted Quick Change Plate Thumb Screw Storage Tray
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A storage tray for the thumb screws of an IF QC plate that is designed to be mounted on an IF Rail organizer.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 35
- Makes
- 0
- Views
- 390
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A small tray for storing the thumbscrews used to secure an Inline Fabrication Quick Change Plate to a Quick Change Base when they're not in use. The tray is designed to be mounted to an Inline Fabrication Rail wall-mounted organizer, although the tray could also serve as a bench-top organizer for the thumbscrews as well.
There are two versions of the tray available: one with magnets, and one without. The version with magnets is recommended, as that is the version the tray was designed around (but I also understand there are a lot of people out there who aren't as obsessed with magnets as I am, so I also made a version without them).
If you opt for the magnetic version, you will need two (2) 9.5mm x 3.2 mm disc magnets. The magnets are designed to be embedded within the print, so don't forget to set a print pause at the appropriate layer so you can pop them in!
Note: Layer shown in the screenshot above is for reference only; yours will likely be at a different layer unless your layer height settings are the same as what I used!