MagSafe iPhone Watch AirPods Charger Stand V3
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A MagSafe iPhone, Apple Watch and AirPods Charger Stand!
- Rating
- 5 / 5
- Likes
- 98
- Downloads
- 686
- Makes
- 6
- Views
- 3,125
- Reviews
- 6
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Update: 01/07/2024 Added another beta version that replaces the Apple Watch charger with a Galaxy Watch charger (slightly wider and deeper). This version also widens/lengthens the slot the houses the area when the cord meets the puck. I don't have this charger so use at your own risk (please send me a DM with modification requests).
Update: 01/05/2024 Added a V3.1 version that increases the length of the AirPods charger so that this space can be used for larger iPhones (Max) and iPhones with cases.
Update: 11/13/2023 I took a couple millimeters off of both the left and right side and shifted the iPhone charger hole up by one and a half millimeters based on some feedback from someone whose iPhone 15 Pro case didn't quite fit.
This stand fits two MagSafe chargers and one Apple Watch charger. One MagSafe charger is meant to hold the iPhone upright and the other is intended to charge AirPods. All charger cords should be fed into the stand from the front/top and then guided down the channels. The AirPods charger cord should be fed up the main vertical corridor for about and inch and then doubled back to reach the channels so as to not force it to bend in an awkward position.
I know what you're thinking, “Those OEM MagSafe chargers are expensive, you want me to burn TWO of them on this print!?” I found a non-OEM MagSafe charger 2-pack (these seem to appear/disappear on Amazon on a daily basis) that costs less than one OEM charger and has the same dimensions. It works just fine although you may not get the MagSafe animation.
This was printed on a Prusa mk3s. There is very little tolerance in the spots where the chargers fit and the cord tracks as I didn't want them to come loose. Feel free to scale the model if your charger(s) do not fit. I recommend at least 0.15 resolution and whatever infill you want. Print it on its face so you don't need supports although the tops of the parts that hold the chargers may come out a little wonky. There will be some bridging on the parts of the print that are hidden after the MagSafe charger is installed.