1 / 6
Ikea Ivar Side Assist | Fall Protection | Railing | Additional Hook
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A small holder for a railing as side fall protection
- Rating
- 0 / 5
- Likes
- 18
- Downloads
- 54
- Makes
- 0
- Views
- 359
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial
A set (2 male + 2 female) is printed within 30 minutes and needs 8g filament.
No support is necessary 'cause the two pieces get interlocked.
The railing itself consists of a round piece of wood with a diameter of 1cm.
Note: For a perfect fit of the railing, you must cut the rod to the correct length. I cut the bar a little too short (obviously) so the brackets don't sit flat against the bar. To correct this, I placed a small screw on one side of the rod to close the gap precisely.
The holders fit all Ivar shelves, whether deep or narrow.