1 / 1
M25.4 rubber grommet wallplate
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Wallplate > ragged hole in wall
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 26
- Makes
- 0
- Views
- 396
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution
Each prints in two half-pieces, in case the wires have already been run through the hole(s).
- wallTunnel.top.stl goes into the hole in the wall
- wallPlate.top.stl holds the M25.4 rubber grommet by its inner groove and slots into the wallTunnel.stl
Print two of each; they are split at 45*. Two nails/screws holds it altogether.
M25.4 rubber grommet from Amazon
If you have an MMU(2) and want a nice flat underside then you can print each part with its .support file(s) in a different material; I printed the actual parts in PETG and used PLA for the .supports stls.