1 / 1
Voron RockNRoll Mod Stilts
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Stabilizing stilts so it doesn't tip over
- Rating
- 4.667 / 5
- Likes
- 103
- Downloads
- 476
- Makes
- 5
- Views
- 1,882
- Reviews
- 6
Updated at source:
Model information
- Source
- Printables
- Category
- Voron Parts & Upgrades
- License
- GNU General Public License v3.0
Intended for use with Voron printers that use the awesome RockNRoll mod by RockNLol. This stops the printer from tipping over if the center of mass is a bit higher.
Print settings
I used the settings recommended in the original mod, so:
- nozzle: 0.4 (100% line width, so 0.4)
- layer height: 0.2
- top/bottom layers: 10
- walls: 5
- infill: 40%
- supports: no, they are built in
- filament: any normal structural material will do
Adjust your settings if needed based on your preferred print setup.
BOM
- 2 x M5 10mm BHCS or SHCS with shim
- 2 x M3 10 or 12mm BHCS or SHCS with shim
- 2 x M5 T-nut
- 2 x M3 'hammerhead' or T-nut
Assembly
Bolt them on to the center of the back extrusion, but don't tighten. Tilt the printer back carefully and adjust the position so that the rockers are flat on the surface. Position both stabilizers so that they both have about equal pressure on them.
