Taillight mount and fender for Delta rear bike rack
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Mount a saddle-post tail light on a Delta Cycle rear bike rack, while improving the rack's function as a fender.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 24
- Makes
- 0
- Views
- 239
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial
The Delta Cycle Megarack Ultra rear bike rack has a strange back end makes it hard to mount a tail light securely. There's a thin metal tab sticking down with a couple of holes in it, as well as two vertical mounting holes on the rack top plate (see the pictures in the link).
This mount accommodates the features of the bike rack, making use of the two screw holes at the top as well as a screw hole the tab (which sticks down through this mount). With this mount, you can attach almost any saddle-post taillight onto the back of the bike rack. It includes a mini-fender that serves as a flange to prevent the taillight from slipping off.
The fender also protects the tailllight from debris thrown by the rear tire, as well as protecting you. The top plate of the rack serves as a fender to protect you from splashing, and the taillight fender improves this function by extending the protection rearward.
See the Post-Printing section below for installation instructions.
Additional hardware required:
- 3 M4 × 16 mm screws
- 3 M4 nylon lock nuts (must be the nylon type)
- 1 M4 washer (optional)
Tools required:
- Bamboo skewer or coat hanger wire (anything that slips into an M4 nut)
- Screwdriver
- Pliers or M4 crescent wrench
- Pencil or pen, or something of similar diameter with a blunt end
Print settings
Supports: Yes
Resolution: 0.3 mm layer height, 0.4-0.6 mm nozzle
Infill: 20% cubic
Filament: Prusament PETG
Notes:
- Enable supports for angles shallower than 35° from horizontal.
- In PrusaSlicer, use the "snug" support setting with normal defaults.
- Put a mouse ear (helper disc in PrusaSlicer) on each end of the fender to prevent any possible warping.
PETG supports don't break off cleanly. Use a paring knife to scrape off the scars. It cleans up well enough.
Installation
- If the rack is already installed on the bike, loosen the rear wheel to slip it downard a bit, to make room for you to slide the taillight mount up onto the rear tab of the rack. Re-attach the rear wheel.
- Loosely fasten two screws and nuts into the rack top plate, so that it's snug but can still wiggle.
- Push the skewer or wire through the horizontal hole, from back to front. This aids in getting the nut into its locking hole, which can be a frustrating experience without the skewer or wire.
- Slide the nut over the front end of the skewer. Work the nut all the way into the hexagonal hole. The hole has a large part for pushing the back of a pencil in to keep the nut in place after the nut settles into the small part. The hole is a loose fit.
- With the nut held in place by the eraser end of a pencil, slide the M4 screw and optional washer into the hole in the back. Tighten with a screwdriver. Remove the pencil once it's tight.
- Tighten the two screws at the top plate.
Category: Sport & Outdoors