Kyosho Blizzard sprocket mod
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Kyosho Blizzard sprocket mod: prevents snow packing up between the sprocket teeth
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 69
- Makes
- 0
- Views
- 466
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Kyosho Blizzard sprocket mod:
Here's the mod I did for the Kyosho Blizzard sprocket. It prevents snow packing up in the area between the sprocket teeth. When snow packs up there, the part becomes a big ice cylinder, and doesn't drive the caterpillar anymore. The indentations in my design prevents that from happening.
I also included the design for the original part.
Instructions
Works best with support under the part. I also used a raft because of the small contact area, but it may not be necassary.
I also used 4 perimeters so the part is very resillient, even when used in the cold (tested to -25°C).
I used 0.1mm layer height for greater accuracy, but 0.2mm is also fine.
Category: R/C Vehicles