Selfie stick upgrade for Radiacode 102/101 "joint"
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€2.01 – €2.45 net (excluding VAT)
For file: kloub rc102 v2.1.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €2.23 excluding VAT (range midpoint).
- Weight reported by the author
- 16 g
- Print time reported by the author
- 2.85 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Intermediate joint for changing the angle of the RC102 holder. Mezikus - kloub pro změnu úhlu držáku RC102.
- Rating
- 5 / 5
- Likes
- 8
- Downloads
- 59
- Makes
- 1
- Views
- 656
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution
Upgrade selfie stick v2 for Radiacode102/101. This spacer-joint allows a smooth change of the RC102 mount.
https://www.printables.com/cs/model/552255-radiacode-102101-selfie-stick-v2
Installation: if I already have version 2 printed and glued together. I use a knife and hammer to separate the glued threaded part from the mount. I remove the tripod thread. I screw the thread into the new joint. Using a rivet nut and bolt, I connect the joint. I glue the whole thing back together with the original bracket.
Print standing up. For higher strength, select in the setup, a larger number of perimeters (walls).
________________________________________________
Upgrade selfi tyče v2 pro Radiacode102/101. Tento mezikus - kloub umožní plynulou změnu držáku RC102.
https://www.printables.com/cs/model/552255-radiacode-102101-selfie-stick-v2
Montáž: pokud již mám vytištěnou a slepenou verzi 2. Nožem a kladívkem oddělím od držáku nalepený díl se závitem. Demontuji stativový závit. Závit našroubuji do nového kloubu. Pomocí nýtovací matice a šroubu spojím kloub. To celé opět slepím s původním držákem.
Tisknout na stojato. Pro vyšší pevnost, zvolit v nastavení, větší počet perimetrů (stěn).