Apple Magic Keyboard 2-in-1: Raiser and vertical stand
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€3.13 – €3.82 net (excluding VAT)
For file: 2 parts_0.3mm_PLA_MK3S_2h55m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €3.47 excluding VAT (range midpoint).
- Weight reported by the author
- 55 g
- Print time reported by the author
- 2.92 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Raiser and vertical stand 2-in-1
- Rating
- 4.8 / 5
- Likes
- 61
- Downloads
- 634
- Makes
- 7
- Views
- 2,926
- Reviews
- 5
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
all available raisers had angles that were too wide for my liking. So I made one, it connects to the keyboard via slide rails, you can also flip it over to keep the keyboard upright when not in use.
Tilt the pieces towards the inside, as in the photo. Supports for angles up to 35°. Infill 20%.
I have included a middle part, with hole for lightning cable (optional printing)
Publish photos of your makes :)