Voron Z Chain Lower mount 4pin dupont mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remix of the Voron 2 Z Chain Lower mount to make a mounting space for a 4pin dupont plug.
- Rating
- 0 / 5
- Likes
- 15
- Downloads
- 58
- Makes
- 0
- Views
- 1,243
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Voron Parts & Upgrades
- License
- GNU General Public License v3.0
This is a remix of the Z Chain Lower mount to allow a mounting point for a single PCB via a 4 pin dupont plug.
Put whatever you want in your voron to monitor the chamber near the bed. It's perfect for an i2c environmental sensor like a BME 280 temperature/humidity sensor, SGP40 VOC sensor or a mix of both - Isik's SGP40/BME280 compact PCB sensor (I'm not sponsored by Isik, I just think it's a cool idea)
The recess in the chain mount is flexible enough to take the 4 pin dupont connector and your sensor just plugs in the front.
Installation
Example
The picture posted is of a SGP40 plugged into a closed voron 2.4 chamber to monitor VOCs during printing and uses the chamber thermister and klipper modules from the Nevermore Max* to control a nevermore micro when VOC's increase.
Github - https://github.com/nevermore3d/Nevermore_Max/tree/master/Software/Klipper
*This project is currently a work in progress 19NOV2023
Installation
- SGP40 connected to raspberry pi host on i2c.1
- Thermister or other temperature/humidity sensor (ideally) - Note the VOC sensor is very dependent on temperature and humidity; but in a closed chamber you could get away with temperature correction only and correct for change in relative humidity
Klipper modules
copy the sgp40.py and voc_algorithm.py modules into klipper/klippy/extras
cd klipper/klippy/extraswget https://github.com/nevermore3d/Nevermore_Max/raw/master/Software/Klipper/sgp40.pywget https://github.com/nevermore3d/Nevermore_Max/raw/master/Software/Klipper/voc_algorithm.py
Klipper config
Using Klipper's temperature_fan PID controller the sgp40.py output tricks the controller into thinking it's controlling temperature (voc) when running a nevermore activated carbon scrubber. The SGP40 sensor relies on temperature and humidity to correctly measure VOC, but with a small assumption that you printer is enclosed we can adjust humidity from an assumed initial temperature of 25C, 50% humidity using temperature alone. Ideally you should use measured humidity and temperature to correct the SGP40 VOC_algorithm.
Here's the example using temperature correction only with PID control:
printer.cfg additions:
|
Mainsail (as per Nevermore_Max/Software/Klipper/reeadme.md)
In order to display the full VOC sensor information in Mainsail, the following command needs to be run once in the mainsail directory:
grep -l additionalSensors * -R | xargs sed -i 's+additionalSensors=\[+additionalSensors=\["sgp40",+g'
Output
Setting the temperature_fan VOC/2 to “60” will enable fan operation when VOC increases.
gcode:
SET_TEMPERATURE_FAN_TARGET TEMPERATURE_FAN=VOC/2 TARGET=60 ; Turn on nevermore air scrubber VOC <= 120

Enjoy :)