Brother Serger overlock thread guide bar
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€1.57 – €1.92 net (excluding VAT)
For file: SergerGudeBar_0.2mm_PLA_MK3S_1h53m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €1.74 excluding VAT (range midpoint).
- Weight reported by the author
- 19 g
- Print time reported by the author
- 1.88 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
This is a replacement for the Brother Serger overlock thread guide bar.
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 64
- Makes
- 1
- Views
- 414
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution
This is a replacement for the Brother Serger overlock thread guide bar.
Added additional height to the model over the original Brother part for increased strength. This was printed from PLA with 15% infill; 6 outer layers were used top/bottom/vertical for resistance to breakage. The pin that holds the bar onto the upright was modelled separately, so it could be printed for maximum strength. When printed this pin was also split in the slicer, with cut sides down to avoid supports. The pin was assembled with dowels, but no glue was necessary due to the tight fit. If you don't have a slicer that will do this, a gcode file is included.
An stl file is included for those that wish to slice themselves.
The OpenSCAD file is included for those who would like to modify the design.