Sunlu S2 Dryer PTFE filament guide, horizontal orientation
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.27 – €0.32 net (excluding VAT)
For file: Sunlu S2 passthrough_0.4n_0.2mm_ABS_MK4IS_21m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.30 excluding VAT (range midpoint).
- Weight reported by the author
- 2 g
- Print time reported by the author
- 20.4 min
- Source material
- ABS
- Estimate material
- ABS
- Estimate printer
- Bambu Lab X1 Carbon - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Sunlu S2 Dryer PTFE low friction filament guide, horizontal orientation - no drilling, no glue
- Rating
- 5 / 5
- Likes
- 75
- Downloads
- 456
- Makes
- 3
- Views
- 2,415
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Sunlu S2 Dryer PTFE low friction filament guide - no drilling, no glue
There are many PTFE filament guide adapters for the dryer but this one:
- Guide filament in most natural way from the roll to the PTFE tube. In fact it is in parallel with the tube and the hole. In other models the PTFE tube is going perpendicular to the dryer's hatch which force the filament to bend and raises the friction.
- Works with closed/sealed dryer. Some other models forces the hatch to be partially opened which does not allow to get the top temperatures reached.
- No drilling holes or glueing the adapter to the dryer. Completely reversible.
- Works great with minimal friction when dryer, PTFE tube and the printer are going to be connected like on the photos. If you have similar setup that is the way to go.
- No additional gear needed (PC4 passthrough, etc.), only the PTFE tube.
Installation
- The plug can be installed in any of both filament holes.
- Remove the original small PTFE tube (5mm long) which is inserted in the hole by the producer.
- Push the plug lightly from the inside of the dryer. Fits only in one orientation.
- Align the plug with the hole.
- Push your new PTFE tube from the outside of the dryer through the hole and the plug. Let the tube stick out 5-15mm out of the support, just like in the photos.
- Again push the plug from the inside all the way in to lock the whole thing.
Related
The Prusa Enclosure top passthrough visible on the photos are available here:
https://www.printables.com/model/644995-prusa-enclosure-filament-passthrough-with-closing-