Miniature Low Profile Buckle
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Miniature 2mm thick buckle for 10mm wide and 1mm thick straps.
- Rating
- 4.833 / 5
- Likes
- 92
- Downloads
- 414
- Makes
- 6
- Views
- 1,939
- Reviews
- 6
Updated at source:
Model information
- Source
- Printables
- Category
- Other Fashion Accessories
- License
- Creative Commons — Attribution — Noncommercial
Miniature low-profile belt/strap buckle that is only 0.42g and 2mm thick. Provided model is designed for 10mm x 1mm straps but the original design file is parametric for relatively easy modification.
Not intended for load bearing applications but does have impressive holding power when pulled laterally. Can be easily disconnected by pressing down on the center button and pulling or by twisting the buckle ends in opposite directions.
Printing requires a very finely tuned first layer as an outwards “elephant foot" will prevent the latch from closing all the way. Cleaning up the hole from the side facing the print bed with a 90° chamfer bit also works if the button doesn't go through all the way.
Recommended print settings:
- 0.25mm nozzle (recommended) or 0.4mm nozzle with “Detect thin walls” enabled
- 0.1mm (recommended) to 0.2mm layer height
- Supports off (max 60° overhang angle)
- 4 parameters lines (optional)
- 100% infill (optional)
Provided STLs contain multiple bodies, so you will need to use the “Split to objects” and “Place on face” options in PrusaSlicer to arrange the individual parts on the print bed. A few variations with different tolerances between the parts are also provided.
3/5/2021 - Added two variations of hooks to attach buckle to mask straps.