Schneider Lisse TradFri Remote holdeer

Ikea Tradfri remote replacement to fit Schneider Lisse white moulded plate switches, there's a few variations but I only actually use the E1743 full and cut design, the steering wheel design kinda worked but i found the remotes poor and the design hard to print with the narrow overhang.

The tolerances are very close but even so you'll find the remote has quite a depth, so check clearances on closing doors, In one of my rooms the door hit the remote but thats probably just the odd placement of my switches (also hence the cutoff design)

Print instructions:

This design requires supports, and they're fiddly too (sorry), print horizontal (so the switch would be pointing up), be careful removing the supports as the prongs holding the centre are very easy to snap. 

The E1743 design re-uses the metal plate that comes with the remotes, it clicks into place but the tolerances are very tight, put the print in place first then push the metal plate until both the top and bottom click into place, the remote then just uses its magnet. So you may need to experiment with scale and materials, the solidworks files are provided but they're a mess.

I printed in “transparent” PETG which turns kinda milky white and matches ok. 

https://www.se.com/uk/en/work/products/product-launch/lisse/#LisseWhiteMoulded
https://www.zigbee2mqtt.io/devices/E1524_E1810.html
https://www.zigbee2mqtt.io/devices/E1743.html