Ego Stubby Nozzle with Latch (Vase Mode)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A stubby nozzle to print in vase mode with a friction fit latch. If you have a printer and .8mm nozzle don't buy one!
- Rating
- 0 / 5
- Likes
- 20
- Downloads
- 122
- Makes
- 0
- Views
- 889
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I tried printing the other version on here which is friction fit and had crush ribs. It worked for a bout a total of 3 seconds in turbo mode before it flew off. These blowers really put some power down especially the 765 model that I have. So I went into fusion and created this.
Printer requirements:
1.Good cooling we are pushing a lot of plastic here.
2. A 0.8mm nozzle.
Print settings on my v2.4 with a (volcomosq and 0.8mm CHT and stealth burner) Steps 1-3 can be used with any other printer you will just have to figure out what the best speed is at this extrusion width and layer height:
1. 0.5mm layer height.
2. 2.0mm line width (Yes it will work)
3. Spiraled outer (Vase mode)
4. 25mm/s for whole print
5. 100% fan after 1st layer and up
To install you will need to slide on the nozzle and once it is set. Give it a good slap on top and you hear a click please watch you other hand so you don't pinch it. to Remove you will need to grab the top of the nozzle and hold the handle. Give it a good tug and you will hear it unclick again.
Enjoy your stubby nozzle.
(Picture is Black ABS from Polymer printed at 247C nozzle temp)