Corny keg tap holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A simple tap holder for the picnic tap style for Cornelius kegs aka. corny kegs.
- Rating
- 5 / 5
- Likes
- 13
- Downloads
- 99
- Makes
- 2
- Views
- 647
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This designs should fit most Cornelius kegs or Corny kegs as the compliant spring is able to adapt to different angles and thicknesses of the rubber ledge.
The clip itself is made to work with diameters from 10-15mm as I'm sure there is some variety to the taps out there as well. Mine is about 13mm and works very well.
The design is made to be printed without support and as lightweight as possible. The final assembly is about 4.5 gram. The parts are quite thin, so you might need a brim or raft to get good bed adhesion.
The toleances on the dovetail are set to zero, so if your printer isn't well calibrated you might want to scale the clip down a smidge, or you might have to trim it a bit after printing.
I printed mine from ABS but PETG or other materials might work even better.
The clip features a truncated dovetail, and should work for any other attachments. These are the dimensions in mm of the dovetail if you want to make your own attachments:
Note the 1mm indent from the sides. This is to make the point less sharp for easier printing.