Zwift Play adapter bars for flat Tri Bar's
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Zwift play controllers are designed for drop bars. These adapters allow fitting to flat Tri-Bars for use on Turbo
- Rating
- 4.5 / 5
- Likes
- 10
- Downloads
- 102
- Makes
- 2
- Views
- 2,286
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Indoor Sports
- License
- GNU General Public License v2.0
The Zwift play controllers are designed to be used on drop bars with a curved 20mm profile bar to attach to. These adapters allow you to install the Zwift Play controllers onto flat triathlon bars 20mm (30mm with tape wrap) for indoor Turbo use ONLY.
You will need
2 x 35mm long M6 Bolts with Hex Heads
2 x M6 Wing Nuts for easy removal
Printing Tips
None: Most default setting on most printers will be OK.
Personally I used Carbon PLA but its not necessary as these are not designed to take load. They are designed to control Zwift and then get back onto your TriBars. As you can see I ran out of filament and had to mix and it still works OK. You will need support for the Hex Holes if you want to make them clean.
Installation Tips
The parts use a z spline locking cut on the external sides of the adapters to avoid the need for a complex hinge (Thanks to Angus from Makers Muse for the tip). This way a single clamp using M6 Bolts and a wing nut can be used to secure the adapter on the hidden inside of the TriBars to avoid snagging risk.
Any suggestions to improve the model welcome.