Rain Gutter Sieve / Regenrinnensieb
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€2.56 – €3.13 net (excluding VAT)
For file: Sieb_0.6n_0.3mm_PETG_MINI_2h14m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €2.85 excluding VAT (range midpoint).
- Weight reported by the author
- 52 g
- Print time reported by the author
- 2.23 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
This can be used to avoid that leafs and other coarse dirt are flushed into the drain hole of the rain gutter.
- Rating
- 5 / 5
- Likes
- 117
- Downloads
- 640
- Makes
- 5
- Views
- 2,511
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Very sturdy sieve. You have to measure your rain gutter drain hole and scale the model accordingly. At my house every drain hole is different because they are handcrafted. Measure the hole crosswise!
The model has a circle with 90mm.
The long spikes should go into the direction of the rain gutter. Prints without supports with the tip down. Use 5 Perimeters to avoid too much stringing. Print in ABS or PETG or some other material suitable for outdoor use.
If you need something for your garage roof, take a look at https://www.printables.com/de/model/743035-raingutter-for-garage-roof-regenablaufgitter-fur-g
Ein sehr stabiles Sieb, das zuverlässig Blätter und anderen groben Schmutz vom Abflussrohr der Regenrinne abhält. Das Model ist zum einstecken und hat 90mm Durchmesser. Da bei mir jedes Abflussrohr einen anderen Durchmesser aufweist habe ich den Durchmesser vorher ausgemessen, einmal in Richtung der Regenrinne und quer dazu und das Model dann im Slicer skaliert. Die langen Spitzen sollten in Richtung der Regenrinne zeigen.
Gedruckt werden kann das Model mit der Spitze nach unten ohne Supports. Hierfür sollten mindestens 5 Perimeter eingestellt werden.
Gedruckt in PETG, aber es geht natürlich jedes Material, dass für den Aussenbereich geeignet ist.
Für das Garagendach gibt es dies hier: https://www.printables.com/de/model/743035-raingutter-for-garage-roof-regenablaufgitter-fur-g